The WF 2012 Swap Meet

Finally posted my Baby Jeep forsale/trade.

1996 Jeep Cherokee Country

Can deliver to winterfest.

mac 'built wheeler ready for winterfest' gyvr
 
I will have some aluminum 3* leaf pack shims in short matter. Anyone want 'em? Offer up a beer.


(Catch: You'll have to drink it with me.)
 
Please see the listing in the MWC forum for updates. Thanks for all the interest!


Folks, just found out we are relocating back to NJ in May. As such, I have even more stuff to sell, too many projects and nowhere enough time to work on them, and I don't want to drag all the stuff back east that I brought out here 8 and a half years ago.

The list:

Anything you could want from a '97 XJ Sport, 4.0 engine has less than 100k miles on it and ran recently on whatever fuel was still in the tank from whenever it was last filled, probably 9 years ago. AX-15 transmission, grey interior. Being parted out.

'89 MJ Eliminator project, really wants a resto-mod, originally a manual tranny 2wd. Has a bed liner & cap, bucket seats, full gauges. I have an extra 4.0 with an AW4, 242, D30 & D35 w/ 3.55's to swap in. Rocker panels need replacing. Would like to sell as-is.

'87 MJ offroad project. This is the ugly beast I've been wheeling, needs quite a bit of bodywork but the bed I started building is pretty cool if I do say so myself. Drivetrain runs fine, D30 (ARB) & D44 (spool) have 3.55 gears. I have a ford T-18 w/ Dana 300 & adapter and a Jeep bellhousing that I was going to swap into it for a granny gear. Sits at 6" on 33's and has stout bumpers w/ a Milemarker 10,500 hydro winch. Would prefer to sell as-is but may part out.

A set of 4 military Hummer wheels & tires with the internal beadlocks.

A D30 high pinion w/ 4.56 gears, Powertrax No-Slip locker, Warn hub conversion and inner shafts, solid round stock & heim joint crossover steering, includes drop pitman arm. Has virtually zero miles since build.

Suspension for 8", includes Skyjacker coils, leaves, Rusty's Hydro shocks, Clayton's Long Arms. Installed and never wheeled, so its all in good shape.

A D60 high pinion from a F350.

A D44 high pinion housing from a F150.

A D44 low pinion housing from an early Bronco w/ parts to convert to disc brakes. Also has radius arms and poly bushings and a new set of ball joints.

A D44 rear end from a Scout that matches the EB D44 nicely.

Two sets of steel wheels for the 5 on 5.5 axles mentioned above, one is 15x8, the other 15x7.

A Dana 20 transfer case from an early Bronco.

A Milemarker 9000 hydro winch.

A receiver mount winch cradle.

Winch bumper, unknown manufacturer.

Crankshaft & connecting rods pulled from a 258.

MJ gas tank in excellent shape.

MJ gas tank skid.

'97+ XJ gas tank skid.

XJ/MJ front skid.

MJ tailgate, red, in great shape.

MJ 2" receiver hitch, mounts to stock bumper brackets.

Miscellaneous stock Jeep wheels & tires.

All sorts of miscellaneous parts from other parted XJ/MJ.

Please PM me for prices. I don't get on here often enough to conduct business through regular posts.
 
IMAG0027.jpg

A/C delete pulley $10.

IMAG0003.jpg

OME 1.5" lift coils + a set of stock isolaters(not shown)= 2-2.25" of lift
S-10 spring = ??? of lift
$100.


JIM.
 
Took my old CB out of the '91 before it went to doug's house. You just need to provide an antenna. Bring it to WF and I'll help you put it in.

Cobra 25 WX ST

Barely used since I put it in the Jeep. $105 at amazon new.

50 bucks to black, 40 bucks to red.
 
I Can Bring

Cobra 25 Limited Classic (CB)

Cobra 19 Plus (CB)

Talk Back by Barjan 320-600 (Not shure what this even is)

2 Cobra 2 foot magnetic mount antennas with Cable

And a hustler 5 ft antenna w mount and cable.

However I do Have to figure out what antenna to keep for the Cobra 75 Wxst that should be in the mail any day. ( i am clueless about CB)..

IF you are a member that does not have a CB these can be Had For a Beer and a Nod.

If You are a non member Make an offer (doesn't have to be much)
 
Ok well I'm in desperate need of a 33/12.50/15. Had my 2 new tires mounted and was going to use the better of the 2 I took off for a spare.....I went there today and the of tires were already cut up and in the dumpster.....so
 
I've got 2 33" swamper radial but it has some bad beads on it. You are welcome to it but it may take the tire guy a couple tries for him/her to get it to seat. These (2) have at least 30% tread you can chose which one you want.
Cardboard
PS. Im in Columbus In
 
IMAG0027.jpg

A/C delete pulley $10.

IMAG0003.jpg

OME 1.5" lift coils + a set of stock isolaters(not shown)= 2-2.25" of lift
S-10 spring = ??? of lift
$100.


JIM.

BOTH SOLD.

JIM.
 
I have a set of (5) 36x12.50x15 Super Swamper TSL's, 4 that that are grooved. One of them as the spare has been plugged in the side wall and is only good as a trail spare, and it is not grooved. The other 4 are not recommended for road use, TRAIL ONLY tires. They are 85% or better tread, each lug grooved in the middle (like Wheelers). 1 of the tires has some pretty agressive weather checking around it, but for some reason the other 3 do not. I can get pictures if there is any interest. These are available for WF delivery as well. These are mounted on some 15x10 black steelies that are 5x5.5 pattern (will NOT fit your stock XJ, TJ, ZJ etc) I am willing to wheel and deal on these b/c I acquired them in a trade, so if your interested, shoot me a realistic offer and you could own these. The badlands has a shop that can mount these up as well!!
 
I have some rustys motor mounts that need new bushings $10. pm me as I don't keep up with this thread very good.
 
Back
Top