5spd_xj
<<the good ol days
- Location
- Dracut, MA
Re: THe NAC Lots-O-Post Thread
TEXT TEXT TEXT!!!!!!!!!!
TEXT TEXT TEXT!!!!!!!!!!
There's not something different about the 35 yoke?
From everything I remember the 30/44/dana300/etc are all the same but the 35 doesn't interchange.
(inside reference: Matt Gaskins having to punch broken strap bolts out of his rear 35 yoke in the Woodpecker after breaking them in the Backyard in '07 because everyone only had 30/44 yokes available)
If it behaves itself, funny I was about to text you about that.
Yo Rob, what did you use for a rear brake hose to the axle?
Dana 35's have a 1.842" diameter through the seal.
30/44/300/etc use the 1.552.
Not sure what else changes though.
So what do you guys think of this? Gonna cut the soft lines on both sides of the hard lines, gonna use some hose barbs and some rubber hose to replace just the hard line section, should work mint, plus it ain't like this this flows a lot of fuel
I need to buy a tranny cooler before NACFest. Any recommendations?
I need to buy a tranny cooler before NACFest. Any recommendations?
I need to buy a tranny cooler before NACFest. Any recommendations?
Go the JY and grab one off a Ford Explorer.
Usually dirt cheap, have 3/8" hose barbs right on them, and work very well.
Just make sure your inlet is the lower one, it doesn't work as well with the fluid falling down through the cooler
AX15s don't need hose barbs, and they never came on Exploders you goof
:twak:
Go the JY and grab one off a Ford Explorer.
Usually dirt cheap, have 3/8" hose barbs right on them, and work very well.