- Location
- Atascadero, CA
ok i have really bad death wobble right after i installed rusty's tie rod conversion steering. i pulled my drive side shaft and knuckle just to clean then, see if there was anything wrong with them and gain the experiance of knowing how to pull them and put them back.
the knuckle came off pretty easy(just some light taps with a hammer but my problem is puting it back on, why wont it go back on the tie rod end thingy's? whenever i try to screw the castle nut on the threaded part of the tie rod end just spins around, any advice as to getting it presses onto the axle?
btw its dana 30
the knuckle came off pretty easy(just some light taps with a hammer but my problem is puting it back on, why wont it go back on the tie rod end thingy's? whenever i try to screw the castle nut on the threaded part of the tie rod end just spins around, any advice as to getting it presses onto the axle?
btw its dana 30