WHAT IS ON YOUR JUNK YARD WATCH LIST?

[99GreenMachine]

E brake cable for a 1999 XJ. My ehaust pipe burned through it. anyone find one or have one please let me know.

Nick

 

[sintax]

E brake cable for a 1999 XJ. My ehaust pipe burned through it. anyone find one or have one please let me know.

Nick

There was a 99 or 2000 in the PaP junk yard up in Ontario off of Miliken when i was there 2 weeks back. It would be a bit of a hike though.

 

[markw]

Sounds like your lifted. Go with 2 YJ passenger cables. Stock cable is too short and will rub the muffler.

Article on it here:

http://www.4x4wire.com/jeep/tech/brakes/xjhoseext02/

 

[TackerT]

Does anyone know where I can get a good price on some 37 12/50 15s or have some for sell thanks.

 

[ridinhigh07]

97 drivers side fender flare preferably blue but if u have all four in black i want it haha...mine flew off on the highway and i have no clue how my brother did it haha

 

[tweakado]

Looking for driver side and passenger side axels for Dana 30 doing the change thing to the bigger joints and eliminating the disconnect. Looked at new ones and ouch my pocket hurts.

 

[Mr.OverKill]

F350 D60 out of a 1979 F350 ( redundant aint I )
a 2000 or newer E350 4X4 van with solid axles, ( matching D60's front and rear )

so has any one seen these items yet?? new order of a sort, any front or rear D60 axles ( hi or low pinion ) DS drop.

 

[Mr.OverKill]

cj or tj folding side mirrors

i still need these too

 

[sintax]

so has any one seen these items yet?? new order of a sort, any front or rear D60 axles ( hi or low pinion ) DS drop.

There was a early 80's chevy with a LP D60 front in the ONT PaP yard. It was missing shafts.

 

[TackerT]

Anyone have a locker any brand for a dana30 let me know

 

[GrimmJeeper]

:greensmok Hello all, this is my first post... just wanted to spread some info:

there is a pretty much jeeps only junkyard in Wilmington, here is the info


AMC Auto Salvage
1310 E. Lomita Blvd
Wilmington, CA 90744

310-830-6880
323-755-2823

90% XJs, a bunch of Tjs, Yjs, and Zjs... and a couple Mjs last time i was there..around october.

junk on!:greensmok

 

[corbinafly]

:greensmok Hello all, this is my first post... just wanted to spread some info:

there is a pretty much jeeps only junkyard in Wilmington, here is the info


AMC Auto Salvage
1310 E. Lomita Blvd
Wilmington, CA 90744

310-830-6880
323-755-2823

90% XJs, a bunch of Tjs, Yjs, and Zjs... and a couple Mjs last time i was there..around october.

junk on!:greensmok

And in case you didn't know, that place is a rip off.:scared: Don't ask me how I know. They pull the parts for you and you pay big time. Better to go around the corner to pick a part and get your hands dirty.

Kyung

 

[GrimmJeeper]

And in case you didn't know, that place is a rip off.:scared: Don't ask me how I know. They pull the parts for you and you pay big time. Better to go around the corner to pick a part and get your hands dirty.

Kyung

good to know, thanks

 

[djblade311]

Black front bumper.

I have a stock 99 blue steel bumper with black end caps and factory fog lamps. Grab a can of black spray paint and you're set. Asking $40

 

[hellbilly04]

I would like a new windsheild from a 90's vintage xj perfeably no cracks.. If ya see a good one...

The pick a part on Beach Blvd in Stanton just brought in 7 Cheorkee's. I was there last Sunday & they were just putting them out. 87-91's all have good glass & body panels except one was hit real hard on the pass side. Be there again this Sunday.

 

[Bent]

Time for me to finish what I started. It’s time for flat top Dana 60 knuckles. Actually from the inner “C”s clear out to the discs and calipers. I would prefer a five on 5.5 lug pattern but I am not even sure they came in anything other than 8 lug. I wonder what they would say if I showed up at the check out counter after cutting them off at the axle tubes? “No really buddy, I cut them off of the bent housing of a gutted Dana 30”. Hehehe

I think this may take a bit longer the MJ badges I’ve just now ran across.

:woohoo:

 

[smASHLEY]

Well, I have received a few messages asking about things that I could use... OTHER then specific baby stuff (because I know guys don't have diapers lying around your house **unless you're wearing them** its not a likely find) I COULD really use some help with finishing touches of my Jeep, as some of you know I was in a car accident in June.

This might be SOMETHING you might actually be able to help out with!
​

THINGS I NEED FOR MY '90 XJ:
Bolts for my bumper
Cross Member
Oil Pan
Harmonic Balancer

***If you get any of these parts PLEASE let me know what I owe you, thank you for keeping an eye out for me, I really appreciate it.***
​

THINGS I NEED ADJUSTED/FIXED/ATTACHED:
(Things listed above)
Bumper
Motor Mount
(My running lights **blinkers** do not work)

And one strange thing about my Jeep, whenever I sit at a red light its as though I get rear-ended and it kicks forward **NO NO ONE is behind me**, but this is concerning.

:flipoff: THANK YOU GUYS FOR HELPING OUT! :flipoff:
http://www.naxja.org/forum/showthread.php?p=243376824#post243376824

Slammer101 aka smASHLEY (more affectioningly known) :compwork:
​

 

[jack96xj]

Well for starters............1997 xj front doors with power windows/locks/mirrors! Know where I can find a set of those?
Front clip off of a 98 xj.
Front driveshaft for a 242 or a 231 if it will be long enough for the rear w/out to much modification. And hell lets face it any part for my XJ that i can get for free I'll take fast as hell.

 

[Mr.OverKill]

Chevrolet 4X4 TH400 transmission, need one bad and willing to travel a little for it, please let me know if you see one in San Diego through the Southern LA / longbeach areas

TIA

 

[GauchoMD]

Hey, most of you probably already know where it is but since I dont, where is the "pick a part" that everyone talks about?? I'm always on the lookout for a good deal on D44 front and rear for my XJ or rear 9 inch or 8.8 inch...