- Location
- Middle Tennessee
Installed a fresh Wix air filter in my XJ. Took out the IAC thinking it was dirty and sticking causing the high idle. It was clean as a new one. I don't know where to look next trying to figure out what is causing it.
Weekend is over...what did you get done?
- Thread starter Mr.Shrek
- Start date
RedHeep
NAXJA #1499
- Location
- Landenberg, PA
Have you checked for a vacuum leak?
Lowrange2
NAXJA Forum User
- Location
- Abbeville, SC
I KNOW I have a Vac leak somewhere but I can't find it to save my life.
- Location
- Middle Tennessee
Not yet. It has just recently popped up. I'm going to try and sort it out over the next few weekends. Hopefully I can find it.
RedHeep
NAXJA #1499
- Location
- Landenberg, PA
A can of starting fluid helps a lot. Spray a little on each of those connections and listen for the rpm change.
- Location
- Nashville, TN
I have a whole workbench full of parts!
Oil change due on the WJ.
Need to put a new CPS in the ZJ.
Have a brake line, calipers, steering gear box, and axle seals for the XJ.
I foresee a little bit of garage time this next week or so. I have to get the ZJ done first so that I can move the XJ over to the side of the garage where the tool chest and work bench are.
Oil change due on the WJ.
Need to put a new CPS in the ZJ.
Have a brake line, calipers, steering gear box, and axle seals for the XJ.
I foresee a little bit of garage time this next week or so. I have to get the ZJ done first so that I can move the XJ over to the side of the garage where the tool chest and work bench are.
cracked-butt
NAXJA Forum User
- Location
- Eastern Tenn.
found out why my ac isn't working. the resistor needs replaced. and still need to find a passenger side window /doorlock switch. and on the look out for new front seats for it.
highspeed
NAXJA Forum User
- Location
- Owens Cross Roads, Alabama
Found two 33" mud terrain tires for spares. Now I should be good for Harlan.
94xjsport94
NAXJA Forum User
- Location
- Carrollton, GA
Georgia Mike
NAXJA Forum User
- Location
- Flowery Branch,GA
Umm....I have have a decent set...cheap for
members 
A few dents & dings but they all open & close as they should.highspeed
NAXJA Forum User
- Location
- Owens Cross Roads, Alabama
If I can get the spare mounted and balanced.....
BTW, should I be looking for some h2 rims?
94xjsport94
NAXJA Forum User
- Location
- Carrollton, GA
I'll send you a PM tomorrow when I pay him.
highspeed
NAXJA Forum User
- Location
- Owens Cross Roads, Alabama
Sounds good. Wanna make sure I plan ahead.
SC Rednek
NAXJA Forum User
- Location
- Winchester TN
Anyone going wheeling this weekend?
- Location
- Camden, SC
cut the seat mount out the XJ last night...... Trying to decide if I want to loose the flat bottom in order to mount my suspension seat or if I want to put the 2 door seat back in and keep the flat with frame rail bottom...... Which would require me to remove the 205.....
highspeed
NAXJA Forum User
- Location
- Owens Cross Roads, Alabama
Might try to go to Chocco this weekend down in Jacksonville. I found some spares so I am itching to go back out.
SC Rednek
NAXJA Forum User
- Location
- Winchester TN
That's about 140 miles for me, not sure it'd be worth it
94xjsport94
NAXJA Forum User
- Location
- Carrollton, GA
It's a fun time. Couple of good hill climbs if you're into that and boat ramp. Hopefully the rain stays away...
Lowrange2
NAXJA Forum User
- Location
- Abbeville, SC
I want to try boat ramp in the gold Jeep... eventually.
SC Rednek
NAXJA Forum User
- Location
- Winchester TN
Are you thinking saturday or sunday?
