- Location
- Rainy side of Washington
You should be able to open it by pulling the plastic trim and screwing around with the linkages. I've had to do that before on my 98.
Weekend is over...what did you get done?
- Thread starter Mr.Shrek
- Start date
Cnickgo
Do you need assistance?
- Location
- Monterey, CA
Haha, If it was a 96- the hatch would already be open!now is just a matter of finding a hatch then getting the damn thing open so I can put the new one on.
Cut the offending sections out. Everything can be fixed with a cut-off wheel!
- Location
- Columbus, In
That's the plan for tomorrow when its 70 out....in December......so much for winter again!
- Location
- Roanoke VA
just got vandalized, bastards
Damn punks, at least they only got the glass, you can scrape it off.
- Location
- Rainy side of Washington
that blows! Should come off the glass with a razor and off the paint with a tiny bit of acetone if you are really careful, the faster you act the better. Don't go too heavy on the acetone or you'll start eating into the paint.
I'm loving it... no heat in the house yet... a warm December means more of my firewood stack sticks around for January/February/March.
- Location
- Columbus, In
Winterfest may actually be wintry this year.....well more than last year!
highspeed
NAXJA Forum User
- Location
- Owens Cross Roads, Alabama
just got vandalized, bastards
That sucks...............
From one MP to another, catch them in the act and prosecute!
revmaynard
NAXJA Forum User
- Location
- Decatur, GA
I did a front and rear brake overhaul (mostly), I got my new rotors/pads and drums/shoes installed. Didn't get to the stainless lines/bleed though. I also went back to new stock shackles and got it sitting level for now!
rocknxj
NAXJA Forum User
- Location
- Clinton, Utah (SLC area)
Sorry to hear about the hatch. You do know about the "D" position for the transmission, right?
- Location
- Columbus, In
Yes but when you are going "R" in the "D" position it tends to die and you lose power brakes! :doh:
Mr.Shrek
NAXJA Forum User
- Location
- Murfreesboro, TN
Been work hard with the scouts building the Christmas parade float ready for the Nashville Christmas Parade. Also beefing up the jeep for it with Coil spacers, shackle relocation mounts, visionX rock light LEDs, overhead console, switch for fog lights, and rancho stainless steel braided brake lines up front.
XJfreakHO
NAXJA Forum User
- Location
- Greensboro NC
Finishing up the final touches on the manche... just need some pinion shims and some spicer 760s to throw my chromos in, then just a few odds and ends and shes good to go.
Will have both jeeps at Uwharrie this weekend, not to mention my entire crew. So if any of yall are planning to come, shoot me a call or text, well be there friday - sunday camping at the Stables (about a 1/4 mile from the outpost, across the road)
336 430 7842
Eric
Last edited:
XJfreakHO
NAXJA Forum User
- Location
- Greensboro NC
Got chromos and joints in, tested er out. Flexes very well. Just gotta get some pinion shims tomorrow, local places didnt have them so taking a short roadtrip in the am to grab them.
XJfreakHO
NAXJA Forum User
- Location
- Greensboro NC
Getting my brothers XJ ready too, 44/9 swap, just needs finished welding the unibody bracing and all, driveshafts, and brakelines.
Sitting on its own weight, hoping to be on the trailer heading to Uwharrie by 5 pm.
Sitting on its own weight, hoping to be on the trailer heading to Uwharrie by 5 pm.
- Location
- Columbus, In
Is that teal or am I seeing things. I've only seen one 97+ that color and my buddy(GoSlowGetStuck) bought it. His is a rust free cali Jeep though.
revmaynard
NAXJA Forum User
- Location
- Decatur, GA
I saw a teal '84-'96 when I was looking for mine, I'd guess it's a rarer color.
- Location
- Nashville, TN
I think by 1997 people were, mostly, over the whole teal car craze of the early to mid 90's.
Molly Ann
NAXJA Forum User
- Location
- Lafayette, IN
I still love it!
