I have a leak out of the back of my 242 around the slip yoke of my driveshaft. I just replaced the seal, but the parts store didn't have one listed for the 242 and I compared my old seal to the one they had listed for the 231 and they appeared identical in size. The seal is properly installed, but is leaking.
I drove about 3 miles today and after I stopped it quickly made a puddle about 1 foot around and fluid was all over the rear diff where it had been leaking while driving. I think it is possible I overfilled the case, but didn't think it was possible I overfilled it that much. I later drove the return trip of 3 miles and it immediatly began to puddle again.
Anyone have any ideas on where to start on this problem?
I drove about 3 miles today and after I stopped it quickly made a puddle about 1 foot around and fluid was all over the rear diff where it had been leaking while driving. I think it is possible I overfilled the case, but didn't think it was possible I overfilled it that much. I later drove the return trip of 3 miles and it immediatly began to puddle again.
Anyone have any ideas on where to start on this problem?