So i bought an RV light after reading about another XJ user using it as a rear dome light. It has two separate LED light boards controlled with a 3-way switch. I need to rewire the 3-way switch. i want:
“Off” = all lights always off
position 1 = led 1 comes on when door/hatch is opened
position 2 = led 2 turns on whether doors/hatch are open or closed
The reading included the diagram below but I’m not clear if it is accurate. I dont know where to ground each LED light or to connect to power from this picture.
Can someone please explain how i wire this correctly? I have the 8 terminal switch in the picture plus 2 leds with + and - leads.
“Off” = all lights always off
position 1 = led 1 comes on when door/hatch is opened
position 2 = led 2 turns on whether doors/hatch are open or closed
The reading included the diagram below but I’m not clear if it is accurate. I dont know where to ground each LED light or to connect to power from this picture.
Can someone please explain how i wire this correctly? I have the 8 terminal switch in the picture plus 2 leds with + and - leads.