- Location
- Wasatch Range
ZJ Fuel Tank Swap continued
New sending unit tank gasket/o-ring. This is a dealer item.
The sending unit o-ring is a very tight fit, so I slathered it with this high-tech lube that would dissolve in fuel. Worked perfectly.
The sending unit retention nut plastic on plastic friction was minimized with a liberal coating of silicone spray lube.
Sending unit assembly installed, fill and vent hoses installed with new clamps, ZJ tank assembly is ready for install.
I already owned an XJ fuel tank skid plate and I wanted to reuse it, however, the ZJ tank is about .75” wider than the XJ tank. The XJ tank skid will fit the ZJ tank with some modification to the passenger side mounting bolt holes.
I used a carbide bit on my die grinder to slot the skid holes until they lined up with the unirail bolt holes.
Modified XJ tank skid plate ready for install. The ZJ tank bolted into place using the factory XJ tank straps.
I added exactly 5 gals of fuel to the tank, fired up my Jeep and drove 2 blocks to the fuel station, where I proceeded to fill the tank. Total fuel capacity was 27.66 gallons.
The first full tank of fuel that I ran through it netted me 368 miles of range, with mixed driving conditions.
This has been a very useful mod. :thumbup:
New sending unit tank gasket/o-ring. This is a dealer item.

The sending unit o-ring is a very tight fit, so I slathered it with this high-tech lube that would dissolve in fuel. Worked perfectly.
The sending unit retention nut plastic on plastic friction was minimized with a liberal coating of silicone spray lube.

Sending unit assembly installed, fill and vent hoses installed with new clamps, ZJ tank assembly is ready for install.

I already owned an XJ fuel tank skid plate and I wanted to reuse it, however, the ZJ tank is about .75” wider than the XJ tank. The XJ tank skid will fit the ZJ tank with some modification to the passenger side mounting bolt holes.
I used a carbide bit on my die grinder to slot the skid holes until they lined up with the unirail bolt holes.

Modified XJ tank skid plate ready for install. The ZJ tank bolted into place using the factory XJ tank straps.

I added exactly 5 gals of fuel to the tank, fired up my Jeep and drove 2 blocks to the fuel station, where I proceeded to fill the tank. Total fuel capacity was 27.66 gallons.

The first full tank of fuel that I ran through it netted me 368 miles of range, with mixed driving conditions.
This has been a very useful mod. :thumbup:
Last edited: