kmanxj5050
NAXJA Forum User
- Location
- Reed City Michigan
Well I'm adding pulling the whole d30, hoping the gears are in good shape and then having smash hole help me put in new bearings and set up gears.
Already have or on order:
Install JCR 1/4 guards (ordering tomorrow) Come in Thursday
Install Winch (ordering tomorrow) Done
Ball Joints
cut leaf pack center pins Done
install right rear parking brake cable This Saturday
rear brake line This Saturday
rear brake hose This Saturday
relocate cb
run power to the front seats
shave 8.25, fat off the edges
install upper control arms Done
cut axle control arm brackets for more droop This Saturday
install AN fittings in trans and run hoses to cooler
install thermostat and gasket
U-Joint at rear axle This Saturday
oil change Done
fix gas tank straps (ordered) Done
axle side upper control arm bushings
Need to purchase.
KWIP wiring harness = debating on this now. Maybe more of a luxury item
rear brake shoes = may be smarter to do after WF and clean out the mud from the drums
distributor = mine is ticking and I need to at least have a spare at WF
BR this weekend?
What's that?
The thing you would of had to do if you tightened the mains![]()
Jeep
Bare minimum:
Replace oil pan.
Replace rear axle seals...again.
Wish list that should happen:
Replace rear axle shafts with all new seals, bearings and retaining plates, keep old stuff for spares.
Rear tire carrier/bumper/hitch combo.
New steering.
Wish list that I hope can happen:
Flat skid plate.
Control arms and track bars.
Tow rig:
replace hitch and add a few reinforcements.
fill propane
give entire rig a good look over.
Trailer:
New tires.
Bearings repack.
See if golf cart will fit on it.
mac 'got to keep working to pay for it all' gyvr
Have new oil pan
Have new shafts, seals, bearings, backing plates.
Ordered a new tire/carrier/bumer/hitch combo.
Ordered new resistor for blower to make it work on more than just "high"
mac 'now to find time to do it all' gyvr
Had a good couple of weeks getting work done.
Oil pan done.
New shafts, seals and diff service done.
New blower motor resistor.
New control arms for the front with the oil pan install.
New steering came today, partially assembled, hopefully installing this weekend.
Pretty much needs to be driven a bit and see what else it might need.
Flat skid and rear control arms probably won't happen until before the crawl.
Tow rig got propane filled.
Hopefully doing hitch on Tuesday if I can get it out of the back yard.
Would like to do some tow hooks on the front if I can with the weather.
Still needs a once over, but at 5 years old and 25k, I pray it doesn't need much.
Trailer still needs worked on, but its covered in a foot of snow at the moment.
mac 'progress' gyvr