T&T Project Low Wagon

Last time I went through that obstacle no problem. If the rear would have been 6" towards the passenger side I would have been fine.

As for the scratch and dent sale, I don't know. This thing works so good I'm tempted to just take a bit longer with my other project so I can keep playing in this one. I can always just start removing sheet metal and replacing sections with tube :D
But then you will have to step up to the IC BOD! LOL
 
Nicely done.
 
sick!
 
After laying it over earlier in the day my enthusiasm was kind of shot when we got to the exit. I'm glad I went for it anyway though cause it made up for it.
 
Very impressive. Anyone who has been on that trail, especially with a 30 knows just how big of an accomplishment that is.
 
Very impressive. Anyone who has been on that trail, especially with a 30 knows just how big of an accomplishment that is.

My JK 30 almost gets more attention than the Jeep :D

The JK 30 has a pinion that's twice the diameter of a standard 30, throw in a quality set of gears, a full axle truss and some RCV's and it makes for a stout little axle that's held up to a considerable amount of abuse.
 
My JK 30 almost gets more attention than the Jeep :D

The JK 30 has a pinion that's twice the diameter of a standard 30, throw in a quality set of gears, a full axle truss and some RCV's and it makes for a stout little axle that's held up to a considerable amount of abuse.
That and the fact you arent a throttle junkie goes a long way.
 
Back
Top