A while back I ran over a paint can (or a can full of somthing) because I had no other choice. It was allready flattened and all that happened was this puffy shit stuck to my jeep. This is such a frigging eye sore and I want to remove it finally. I've attatched pictures below but how the fawk can i get this shit off??
You're gonna lose your stripes no matter what you use so plan on it. Try a heat gun to loosen the stripes and peel slowly at a 90* angle to the paint. Clean up with Acetone or Goo-Gone.
The red/orange fade is a digital photo thing from the flash and the clear coat. It's not really like that, mine does it too.
I allready removed those rubber mouldings that run across the doors, the black right above them is a decal, the stuff below the mouldings is paint. I picked myself up a set of late model moldings because I figured these would be toast. Thanks for the suggestions.
LOL not to get off topic but is there any cleaning product Billy Mayes DOESN'T sell???
Back to the topic, I've found that WD-40 is great for getting tar and other goo off the side of your jeep. I've also found that the armorall plastic wipes (the ones in the purple container) are great for getting tar and goo off also. Follow it up with a good wash after either of the two and your Jeep is back to looking good again.
LOL not to get off topic but is there any cleaning product Billy Mayes DOESN'T sell???
Back to the topic, I've found that WD-40 is great for getting tar and other goo off the side of your jeep. I've also found that the armorall plastic wipes (the ones in the purple container) are great for getting tar and goo off also. Follow it up with a good wash after either of the two and your Jeep is back to looking good again.