POSJ
NAXJA Forum User
- Location
- Minot ND, Unfortunately
So I scored a Superdooty axle today, needs work but got it for cheap. I've read there are differences between the 05-07 and 08-10,but don't know what they are...anyway here are pictures.
as far as ive read i think the older ones have d50 gears in them and not actual d60 gears
ahhhhhh....So cool thing from what I can figure is that it is a Dana Super 60.
Started pulling it apart, found something interesting but I was expecting it...the yoke didn't turn and it had an ear broken off...the spider gears and center pin are jammed in the housing. Didn't give it too deep of a look but it looks like the center pin broke.
I need 2" spacers on the rear to match the front width, so realistically I'll probably go that route...I was also looking and going with bigger shafts since I'm replacing the carrier already...idk. Haven't gotten that far in my planning yet.
DITTO on the early 50's some guys run them. I believe axle shaft diameter is the same just smaller ring gear!Dana 50 is only 99-04. Everything after was a 60 or bigger. 256 should be the ring gear size in millimeters. I THINK that's out of an 08-10. Could be wrong tho.