Muad'Dib
NAXJA Forum User
- Location
- Bend, Oregon
Ok im sure this is really stupid, but i have a question...
Today after work, i had to fix a transmission leak at the disconnects. When i was finished, i jacked the jeep back up at the normal spot and started to let it down. It slipped off the corner of the pumpkin where it meets the passenger side axle shaft, and landed right on the lower section of the oil pan.
The pan now has a good sized dent in it where it met the jack. Id say its dented at the most 1".
Oil pressure is the same, and everything seems ok. No oil leaks etc.
Should i worry about this? Can i wait till i build my stroker to replace the oil pan? (it could be a year before i do so). I just dont want to pull that damn thing for the third time in 2008!!
Advise and stupid remarks appreciated :roflmao:
Today after work, i had to fix a transmission leak at the disconnects. When i was finished, i jacked the jeep back up at the normal spot and started to let it down. It slipped off the corner of the pumpkin where it meets the passenger side axle shaft, and landed right on the lower section of the oil pan.
The pan now has a good sized dent in it where it met the jack. Id say its dented at the most 1".
Oil pressure is the same, and everything seems ok. No oil leaks etc.
Should i worry about this? Can i wait till i build my stroker to replace the oil pan? (it could be a year before i do so). I just dont want to pull that damn thing for the third time in 2008!!
Advise and stupid remarks appreciated :roflmao: