- Location
- Camden, SC
Something to think about. IDK why I didn't suggest this when we chatted..... :eeks1:
before the crawl my junk needs.....
- Thread starter shortxjdoug
- Start date
Something to think about. IDK why I didn't suggest this when we chatted..... :eeks1:
- Location
- Mayesville SC
It was on sale and I think I may get the front locked as well. BUT it has been shipped and I am just a little hard headed.
- Location
- Nashville, TN
1. New u-joint in front drive shaft - DONE
2. New driveshaft straps - DONE
3. New front pinion yoke - DONE
4. Repair spring holder on drivers side DONE
5. Repair snapped off bolt in the differential housing -DONE
6. Replace fluid in rear axle DONE
7. Repair broken track bar DONE
8. Get one new 31" MT DONE
9. Pick up spare long shaft DONE
10. Pick up spare short shaft DONE
11. Route cowl air induction system DONE
12. Mount new spare on factory rim DONE
13. Fix negative battery cable DONE
14. New ball joints DONE
15. New tie rod to pitman arm DONE
16. New tie rod to left steering knuckle DONE
17. New tie rod end at the left steering knuckle DONE
18. Replace Durango steering box with OEM DONE
19. New power steering fluid reservoir DONE
20. Replace front skid plate
21. Oil change DONE
22. New brake calipers on front axle
23. New brake line on drivers side
24. Inner axle oil seals on front axle
25. Measure bump stop height and add hockey pucks as necessary
2. New driveshaft straps - DONE
3. New front pinion yoke - DONE
4. Repair spring holder on drivers side DONE
5. Repair snapped off bolt in the differential housing -DONE
6. Replace fluid in rear axle DONE
7. Repair broken track bar DONE
8. Get one new 31" MT DONE
9. Pick up spare long shaft DONE
10. Pick up spare short shaft DONE
11. Route cowl air induction system DONE
12. Mount new spare on factory rim DONE
13. Fix negative battery cable DONE
14. New ball joints DONE
15. New tie rod to pitman arm DONE
16. New tie rod to left steering knuckle DONE
17. New tie rod end at the left steering knuckle DONE
18. Replace Durango steering box with OEM DONE
19. New power steering fluid reservoir DONE
20. Replace front skid plate
21. Oil change DONE
22. New brake calipers on front axle
23. New brake line on drivers side
24. Inner axle oil seals on front axle
25. Measure bump stop height and add hockey pucks as necessary
RedHeep
NAXJA #1499
- Location
- Landenberg, PA
I had a suggestion given to me to lock the front and keep the rear open in Moab and was surprised how well it worked. You can still turn and it climbs just like both ends were locked.
- Location
- Columbus, In
I've just git a few more things to do:
Oil change
Rear pads and rotors
Install e brake cables
Load cooler and clothes
Maybe paint the interior tubes of the cage
Muster up the strength to wake up at 6 on a vacation day!
Oil change
Rear pads and rotors
Install e brake cables
Load cooler and clothes
Maybe paint the interior tubes of the cage
Muster up the strength to wake up at 6 on a vacation day!
- Location
- Southwest IN
I pulled the Jeep into the garage and painted my HoBoxes, that's as far as I have gotten.
Still need to find a trailer...
Still need to find a trailer...
94xjsport94
NAXJA Forum User
- Location
- Carrollton, GA
I confirmed I can borrow a trailer. One step closer!
shortxjdoug
NAXJA Forum User
- Location
- Chattanooga tn
Install spare ps pump and cooler
Leaf spring clamps
With my schedule this might take a week
Leaf spring clamps
With my schedule this might take a week
- Location
- Nashville, TN
1. New u-joint in front drive shaft - DONE
2. New driveshaft straps - DONE
3. New front pinion yoke - DONE
4. Repair spring holder on drivers side DONE
5. Repair snapped off bolt in the differential housing -DONE
6. Replace fluid in rear axle DONE
7. Repair broken track bar DONE
8. Get one new 31" MT DONE
9. Pick up spare long shaft DONE
10. Pick up spare short shaft DONE
11. Route cowl air induction system DONE
12. Mount new spare on factory rim DONE
13. Fix negative battery cable DONE
14. New ball joints DONE
15. New tie rod to pitman arm DONE
16. New tie rod to left steering knuckle DONE
17. New tie rod end at the left steering knuckle DONE
18. Replace Durango steering box with OEM DONE
19. New power steering fluid reservoir DONE
20. Replace front skid plate DONE
21. Oil change DONE
22. New brake calipers on front axle DONE
23. Inner axle oil seals on front axle DONE
Twenty three up, and twenty three down - let's Crawl!
2. New driveshaft straps - DONE
3. New front pinion yoke - DONE
4. Repair spring holder on drivers side DONE
5. Repair snapped off bolt in the differential housing -DONE
6. Replace fluid in rear axle DONE
7. Repair broken track bar DONE
8. Get one new 31" MT DONE
9. Pick up spare long shaft DONE
10. Pick up spare short shaft DONE
11. Route cowl air induction system DONE
12. Mount new spare on factory rim DONE
13. Fix negative battery cable DONE
14. New ball joints DONE
15. New tie rod to pitman arm DONE
16. New tie rod to left steering knuckle DONE
17. New tie rod end at the left steering knuckle DONE
18. Replace Durango steering box with OEM DONE
19. New power steering fluid reservoir DONE
20. Replace front skid plate DONE
21. Oil change DONE
22. New brake calipers on front axle DONE
23. Inner axle oil seals on front axle DONE
Twenty three up, and twenty three down - let's Crawl!
- Location
- Middle Tennessee
Mark and Travis came over and we got some stuff done.
We changed both diffs and t-case in Mark's Jeep.
We also had to swap out the main fuel line in my XJ before we could even start the day. We adjusted my passenger side front door and installed a new seatbelt retractor in the back.
I think I will work on the A/C delete and belt install next weekend and try to knock that off the list too.
- Location
- long branch, nj
94xjsport94
NAXJA Forum User
- Location
- Carrollton, GA
Mostly posting this here so i dont forget anything.
Bottom cage tie ins
Electric Line lock
Move Cb antenna to front bumper and install new coax cable
Oil change and 51515 filter
Spare parts box
Install cherry bomb muffler and wrap it
Load it up on a trailer and drive north.
Bottom cage tie ins
Electric Line lock
Move Cb antenna to front bumper and install new coax cable
Oil change and 51515 filter
Spare parts box
Install cherry bomb muffler and wrap it
Load it up on a trailer and drive north.
- Location
- Camden, SC
Seat fixed. Steering works atm. Working on H1 rim reinforcing now. I need to swap my steering shaft and steering column but idk if I will be able to get that done.
- Location
- Mayesville SC
Oil & Filter Changed :repair:
Locker installed:exclamati
Body bolts checked and tightened
Plus the new light arrived!:yelclap:
Locker installed:exclamati
Body bolts checked and tightened
Plus the new light arrived!:yelclap:
- Location
- Warsaw, IN
Re: Re: before the crawl my junk needs.....
Think we're looking pretty good now. Got front locker in too.
Need to pick up a set of wheel studs.
Think we're looking pretty good now. Got front locker in too.
Need to pick up a set of wheel studs.
89eliminator
NAXJA Forum User
- Location
- Delphi, IN
i keep taking more crap off my jeep haha. gotta mount my new battery box, fix my flex joint on trackbar, maybe put in new TREs, give the jeep a complete once over.
- Location
- long branch, nj
Install 235s picked up falken wildpeak at
Install front tow hooks need to put on
Oil Change done
Tune up done
Spark plugs done
Change CPS think this is going to happen now... throwing a p1391 code
Register, plate, and inspect it registered and plated.. need cel off to pass inspection
Get a spare tire done
Redo ground wires
Get battery hold down
Align
Fix AC fan only works on low... gonna swap out the switch to see if that works
Hopefully get most of this stuff except the tires and alignment done this weekend. The list just keeps getting longer now.
Install front tow hooks need to put on
Oil Change done
Tune up done
Spark plugs done
Change CPS think this is going to happen now... throwing a p1391 code
Register, plate, and inspect it registered and plated.. need cel off to pass inspection
Get a spare tire done
Redo ground wires
Get battery hold down
Align
Fix AC fan only works on low... gonna swap out the switch to see if that works
Hopefully get most of this stuff except the tires and alignment done this weekend. The list just keeps getting longer now.
- Location
- Columbus, In
AC is gonna be your friend!
- Location
- Painted Hills, Indiana
To do:
Register for crawl - Done
Swap out rear leaves - Done
Install shackle relocation kit - Done
Weld cage to shackle relocation kit - Ready to weld
Raise the shock mounts on rear axle - Ready to weld
Trim Shackles - Done
Double check brakes/adjust drums
Idler pulley - bought
Replace windshield, if time allows
Register for crawl - Done
Swap out rear leaves - Done
Install shackle relocation kit - Done
Weld cage to shackle relocation kit - Ready to weld
Raise the shock mounts on rear axle - Ready to weld
Trim Shackles - Done
Double check brakes/adjust drums
Idler pulley - bought
Replace windshield, if time allows
