Ok, deeeep breath. Let it out slow. I'm in my happy place!
NOT! :smsoap:
**** this Jeep! I have been soaking the front axle nuts for days with PB, tried long breaker bar with a long pipe. Even used a floor jack on the breaker bar. All to no avail. I am sure it is possible to get this mf'er off, but I have about had it trying.
If I cut the knuckles off near the ball joints, would the whole hub/knuckle/shaft slide out? At this point I will gladly sacrifice the knucles and drop the cash to replace them.
Any thoughts appreciated.
Whew! :wow:
Todd
NOT! :smsoap:
**** this Jeep! I have been soaking the front axle nuts for days with PB, tried long breaker bar with a long pipe. Even used a floor jack on the breaker bar. All to no avail. I am sure it is possible to get this mf'er off, but I have about had it trying.
If I cut the knuckles off near the ball joints, would the whole hub/knuckle/shaft slide out? At this point I will gladly sacrifice the knucles and drop the cash to replace them.
Any thoughts appreciated.
Whew! :wow:
Todd