robhurlburt
NAXJA Forum User
- Location
- lexington,ky
I am doing a S-10 bastard pack, and i didn't think the head of the bolt was big after being ground down to fit in the axle (centering pin), so i put a washer in between the bolt and the spring pack. As you may know, the holes in the S-10 leaf are slightly larger than the stock springs, bvut the hole in the axle is small for the stock centering spring.
Now i am thinking this is a bad idea. I would think the spring pack should sit flat on the axle, but at the same time, i am unsure if the thin washer could cause any issues.
Thoughts?
The U-bolts are not tightened in this pic.
Now i am thinking this is a bad idea. I would think the spring pack should sit flat on the axle, but at the same time, i am unsure if the thin washer could cause any issues.
Thoughts?
The U-bolts are not tightened in this pic.