RWKHausSupply
NAXJA Forum User
- Location
- yorba linda, Cali
Well I am doing a swap to a 8.8 and figured that since TnT was running special adn the upper rear truss for the 8.8 and the u-bolt eliminators were a good deal (to me at least) I figured I would try them both out.
I was a little worried that the truss may not fit as exact as the picture kinda shows. Well it fits exactly as it shows on thier web page. Very contoured. Here are a few pictures before the eliminators are welded on... I just need the spacing to get them tacked on before I slide the axle under the XJ on wed when I set it up for the right pinion angle..
I only did about 1-2" beads about every 1-2" to try and minimize the amount of tube warping from the heat..
I was a little worried that the truss may not fit as exact as the picture kinda shows. Well it fits exactly as it shows on thier web page. Very contoured. Here are a few pictures before the eliminators are welded on... I just need the spacing to get them tacked on before I slide the axle under the XJ on wed when I set it up for the right pinion angle..
I only did about 1-2" beads about every 1-2" to try and minimize the amount of tube warping from the heat..