Supermanxj's Winter Project

[Hammered]

looks pretty pissed... I dig it.

 

[5spd_xj]

x2, Keep up with it, you gotta get that beast goin!!

 

[Supermanxj]

After much fighting with rust.... i decided i am going a different route.

Buggy

hahahahahah three jeeps for me!!!

Plan is to strip green one of everything and scrap that rusty piece of SH*t and then attack the other one with a sawzall and buy some lexan!!! i have a line on a HP d44 and 9 inch out of a 76 fs bronco so those will be goin in!!!! but... i think i will have the green one at NAC fest just so i can wheel and beat the living snot out of it!!!! and then transfer everything!!

 

[Hammered]

Whered you get that?

 

[Supermanxj]

Appalachianxj on Pirate 4x4... he works at appalachian offroad.

 

[Andy in Pa.]

Good, I am glad someone bought that, it seemed like a waste to just scrap it. I am a little confused about the front of that cage though, I see the halo going around and along the front of the top of the windshield, but are there any bars that tie it in from the footwell floor? The one pic looks like there is a tube from the "B" pillar hoop on the pass side that ran to the floor in the pass side footwell, but then it looks like its cut off in the pic...(?)

 

[Supermanxj]

Good, I am glad someone bought that, it seemed like a waste to just scrap it. I am a little confused about the front of that cage though, I see the halo going around and along the front of the top of the windshield, but are there any bars that tie it in from the footwell floor? The one pic looks like there is a tube from the "B" pillar hoop on the pass side that ran to the floor in the pass side footwell, but then it looks like its cut off in the pic...(?)

Th a-pillar is cut off.the way it was designed the seat bar and a pillar bar came together at the same spot... so getting in and out was a PIA!! i will be putting new a-pillar bars in further towards the firewall and and tie the two side together to make a dash as well.

 

[Supermanxj]

oh yeah... no interior and door less!!!!
up next is:

1. rocker protection
   2.t-case skid
   3.take SOLID d30 cover off DD put on beater.
   4.(possibly put d35 aussie in d30 if i have time)
   5.take jks adj track bar of DD put on beater
   6.rear shackle
   7.rear bump stops
   8.put in rear d44 w/ aussie
   9.Rob the 33in. Summit Mud Dawgs off my pops bronco

Cant wait for NACfest