offset ball joints

[Prepmech]

Does anyone know where to get offset ball joints? AEV used to have them on their web site, but not anymore. I know specialty products co. makes some, but I can't find anyone that sells them.

 

[ChiXJeff]

Phil's Inc. (http://www.philsinc.com) in Evanston can get them.

 

[pfogle]

Check at http://www.specprod.com/ and they might be able to give you a vendor in your area.

 

[JEEPZZ]

I picked up a set for my '87 XJ at Napa.

 

[Prepmech]

Ok, the people at napa were no help. They could not find any for me, I also tried their web site with no luck. I found the spc performance stuff at philsinc.com, but no jeep ball joints. Anyone know of anywhere else to get them?
Thanks for all of the help.

 

[pfogle]

I'll try and get you both SPC part numbers, and NAPA part numbers tomorrow.

 

[desertjeeper]

I just did a search on napa's website www.napaonline.com for my '90 and found 4 different offset upper joints they have:

1/2 degree part number NCP2642972,
1 degree part number NCP2642973,
1 1/2 degree part number NCP2642974,
2 degree part number NCP2642974

they are $91.99 each.

 

[egon]

Moog and TRW makes offset ball joints. Near me they are cheaper then the Napas. Moog K7403; TRW 104309.

Lower Ball Joint
ADJUSTABLE BALL JOINT - ALLOWS UP TO 1 3/4 DEGREE CAMBER/CASTER ADJUSTMENT

Hope this helps.

--Matt

 

[Prepmech]

Now I have a new problem. I can find the ball joints for a '99, but not for a '00. Is this because my LP dana 30 uses different ball joints, or have they just not updated the web sites? I would rather use moog parts. I had a buddy that sells moog try to find me some, but he didn't come up with anything. He was probably just too lazy to look.

 

[egon]

Prepmech,

This site should help. https://mfr.ccitriad.com/mfrcat/ext...&extusr=FMOGuest&extsupplier=FederalMogulFull It lists all Moog parts.

--Matt

 

[Deaver]

They are available from a stealership, but I'm sure you will pay

05014876AA Ball Joint - 0.5 degree
05014877AA Ball Joint - 1.0 degree
05016972AA Ball Joint - 1.5 degree

Ref: http://home.sc.rr.com/janet/TSB/02-12-99.htm

 

[pfogle]

Specialty products catalog shows that offset balljoints application for '97-01 Cherokees part numbers are 23510 - 23540. that's 1/2 degree, 1 degree, 1 1/2 degree, and 2 degrees positive or negative.

Anyone that sells specialty products should be able to order those.