2000bluexj
NAXJA Forum User
- Location
- Mass
well, my original post was lost in the data that was lost recently, so here is a new build thread for those of you who are interested in running 44 outers on your 30.
I bought a used High pinion 30 housing from RCman a while back, and started cutting everything off this past week. Finished cutting everything off today, now just have to grind and clean up the tubes for the new "c".
Problem with the 44 "c". The tubes are bigger on a 44 than a 30.
What im doing: My new "c" is coming from a 3/4 ton gm 10 bolt. It has 3 inch tubes. I will be ordering some 3 X .25 X 3ft piece of DOM to sleeve the 30 tube with so that i can install the "new" knuckle yokes. For shafts im planning on waggy shafts with a 30 spline locker, chevy 1/2 ton outers with high steer. gears will probably be 4.56, going to set those up my self to learn how to do it. I will be updating this thread has time goes on and more stuff gets done. stay tuned.....
Joe
I bought a used High pinion 30 housing from RCman a while back, and started cutting everything off this past week. Finished cutting everything off today, now just have to grind and clean up the tubes for the new "c".
Problem with the 44 "c". The tubes are bigger on a 44 than a 30.
What im doing: My new "c" is coming from a 3/4 ton gm 10 bolt. It has 3 inch tubes. I will be ordering some 3 X .25 X 3ft piece of DOM to sleeve the 30 tube with so that i can install the "new" knuckle yokes. For shafts im planning on waggy shafts with a 30 spline locker, chevy 1/2 ton outers with high steer. gears will probably be 4.56, going to set those up my self to learn how to do it. I will be updating this thread has time goes on and more stuff gets done. stay tuned.....
Joe