Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
The drivers seat on my 96XJ needs to be replaced, after 400000 miles it shows some wear.
Looking at these -Corbeau #70019 seats at 4wd .
Any other suggestions and personal experience accepted.
FYI, it's. It too hard to adapt the stock XJ sliders for corbeau seats. I just used some 2x1/4" flat stock, and drilled the holes for the stock bracket and lined up holes for the corbeau. Worked fine, and you could add a couple welds of you wanted it more secure.
I also have a driver's corbeau seat bracket siting on a shelf if you're interested.
I just installed corbeau Moab seats in my 2000. I used the corbeau brackets I highly recommend them it’s way easier when doing install and they work great. The seats sit about an inch higher than stock so if your tall it could put your head in the roof. They are a little wider than stock so ther rub the center consul a little. They feel a lot firmer than stock. I am 5 foot 11 and I still have room for my head and I have a full roll cage but if I was any taller it could be a problem.
i have the PRP daily driver seats and love the lower side for getting in and out eaiser but i find they like to steal everything out of my pockets. made them fit factory brackets with a little bit of modification