Search results

Check the normal stuff. I was looking at all of the TSBs for my 97. There is one for what you are describing, mine does it too. Basically the factory would put a small t/case drop on and a new driveshaft with a damper built in. I think the 97+ are more prone to vibes especially if lifted...

I put mine on the firewall on pass side. Running another XJ elec fan with it. No problems at all.

We cleaned them with a propane torch. Get them good and hot and it burns off all of the junk. If it is failed electrically then no joy, but otherwise it works.

Looking for 3.5" XJ super ride with full spring packs. Possibly shocks too. 64081. KC, MO area.

Nope. No cats does absolutely nothing to the sensors. If you have a front and a rear, no cats will cause a check engine light and a low catalyst efficiency code, but it will still run the same. May smell rich as the cat isn't burning off the excess hydrocarbons, but everything else will be...

NO. Remove backpressure from your vocabulary. Differing flow rates may push the power band up or down though. The freer the flow, usually the higher up peak torque is. If everyone says that freer flow will burn a valve, how come you don't have problems with open headers or zoomies on...

GM EOS. Engine oil supplement. ALWAYS add this or something comparable during flat tappet engine break in. 1/2 bottle with every oil change is probably enough. I have heard that they are discontinuing it, but heard most dealers still have it.

Sold. Thanks Naxja.

It has a little over 191k, but runs great. Doesn't burn oil and has good power. I drive it daily and work for an engine supplier. If it was weak, I'd have already replaced it. Shoot me some pics and details on yours. Location?

$3350?

Never got any pics. Having trouble posting stuff too for some reason. Price is flexible if I can sell soon. Forgot it is a 6cyl and has a new o2 sensor. Would entertain trades for newer 4dr xj.

You can click on my name at the left or [email protected]@spammerssuck.com (remove everything after the first.com)

I really want something that I won't have to work on much. I'm looking at a 99. This was just my winter vehicle. I have an 03 Mach 1 also. However, send me pics. I'll look at anything.

I kinda like the thing. Never skips a beat, just wanting to pay down debt and get a newer 4dr for ease of kid hauling. Thanks for the kind words.

Asking $3500, but don't need to sell. Would like to get a 4dr so I can put the kid in easier. Some parts needed replacing, but since I drove this every day, I replaced many just so I didn't have to worry about them. Body is straight, with a little rust on the bottom of the doors, but you have...

There really isn't a spec for milling the block that I know of. We always assembled everything, measured down to the piston, figured gasket compressed thickness and whizzed it off. Sometimes we run the piston out of the hole a bit for compression too. Yes, you can figure it all, but with it...

Not sure if that one had a reservoir that you needed to swap over or not. My 89 did. I kept losing fluid and finally re-tightened the "hoseclamp" that holds the reservoir on the MC. No more lost fluid. Not sure if yours is like that or not. If so, tighten it up some and recheck.

close. Meter is funked up. I checked again last night. Wouldn't work on 3 of the ohm scales. Kinda weird. Been using it for years with no problems. I replaced the IAT and CTS anyway. Still an off idle stumble. Going to replace the TPS anyway. MAP voltage seemed ok. Crank sensor was 227ohm, which...

My 89 was getting horrible mileage, rough idle, stumble off idle, etc. New plugs, wires, cap, rotor, fuel filter, o2 sensor, cleaned throttle body, sea foamed it, set TPS, no dead spots found, etc.etc. No change and getting 11 mpg. Has gotten over 20 before. Checked manifold air temp...

I have 2 sets of remanufactured and flowed 19lb injector sets(6ea). $129 shipped. These are Mustang injectors and awesome upgrades for the 4.0. I have tons of brand new 24lb injectors. set of 6 $129 shipped. Set of 8 $149 shipped. 800-841-6060 and ask for Joshua...