• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Search results

  1. Jeepm@n

    Class 3 hitch/ alternator/ power steering pulley/ exhaust/needed

    99xj is what I have. Pulled my trailer on my land full of firewood and heard a pop. Need power steering pulley, alternator, exhaust, and class 3 hitch needed.
  2. Jeepm@n

    2" receiver hitch needed

    As the title states. Looking for a receiver hitch. I have new nut strips for both sides so no hardware needed. Broke my hitch pulling someone out. Glad I found that it was rusted then and that no one was hurt.
  3. Jeepm@n

    97-01 rear hatch needed

    Looking for a 97-01 rear hatch in good shape. Needs rear defogger, and tint. Prefferablly maroon in color. Unless someone is willing to change the glass for a decent price.
  4. Jeepm@n

    hard start when cold, rough and low idle

    Here's what it is. 1999 Cherokee 184K miles AW4 NP231 Meyer plow, air shocks on front and rear. I started it when it was 33 degrees out. It cranked a while and then idled at about 7-800 Rpms. I had to give it a bit of throttle to keep it from dieing and to start. If you give it gas and let...
  5. Jeepm@n

    Dodge Neon 4 port Fuel injectors

    I have 7 junk yard pulled 4 port fuel injectors. They are from the Dodge Stratus and Neon's. I had 8 but can't find the 1. If I do find it I'll throw it in. I'm looking for $70 shipped. They fit the 91-96 XJ's. I will trade for the upgrade injectors for the 99 and up or let me know what you have...
  6. Jeepm@n

    Nearest rust free state to northern WI?

    Been thinking as I crawled under the Heep seeing the rust after just one winter. It may be wise to get a clean rust free shell, 2wd, or complete XJ/MJ as a long term plan. What is the closest state with little to no rust on their vehicles?
  7. Jeepm@n

    Leaf spring options on plow XJ?

    I have a 99XJ that has a 6'-6" Meyer plow. The front ball joints, steering knuckles, axle shaft joints, brakes, and shocks are all new. I have fully adjustable air shocks front and rear. I noticed when I put the ballast (500lb) in the back that even with the air shocks it wanted to hit the bump...
  8. Jeepm@n

    Exhaust

    I need a new exhaust for my 99. I use it to plow, pull my boat, utility trailer and camper. I put around 4000 miles a year on it and I'm tired of replacing exhaust. Any ideas on a quiet stainless system that is around $300 or less. That or know of a place near Green Bay or north of there that...
  9. Jeepm@n

    Jeep Ecco's and GS/A tires

    I have 4 Ecco rims and 225 75r15 tires. They are Goodyear Wrangler GS/A tires that have about 3 seasons left on them. Naxja guy's I'll take no less than $225. http://greenbay.craigslist.org/pts/2702627590.html I would do partial trade for black leather seats, rolling tool boxes, cordless...
  10. Jeepm@n

    Ball joints both sides or one? what brand?

    Advice needed. Ok my 99 has a bad steering knuckle and u-joint on the passenger side. I was going to replace the axle as a whole but after some thought I'd still need to replace the hub bearings and u-joints anyways. So I guess my question is do I need to change the ball joints on the drivers...
  11. Jeepm@n

    3-4.5" lift wanted and 31" tires

    Future brother-in law just bought an 87 Cherokee pioneer. He wants a mild lift and tires. Let me know what you have. No add a leafs or blocks for the rear.
  12. Jeepm@n

    Will my Neon 4 ports work on my 99?

    Ok I have a 96 XJ and I bought 4 port Neon injectors (0280155710) for and never put them in. I just bought a 99 and would like to use them in there. Will these work? They flow the 238cc at 43.5psi. Other wise look at post 7 & 8 in this thread it flows the same as the ones they recommend...
  13. Jeepm@n

    99 rotor sizing?

    I know 99 was the year they started switching rotor's out. What I found last night was my brake grinding on the driver side. When I pulled it apart I found someone put two flat washers behind the rotors on every stud, and it was rubbing on the bottom edge of the brake pad onto the rotor. How do...
  14. Jeepm@n

    Opinions on alternator

    Ok my 96 is being sold. I bought an alternator today out of a Dodge Dakota with a 318. As I was putting the wiring on the alternator I snapped off one of the little studs on the back of the alternator. There is the large positive which is fine the two larger negatives and two smaller ones that...
  15. Jeepm@n

    97-01 Xj wanted

    I need a new XJ. Needs to be under $2500. No vehicles with a lift over 1.5" Must have: little to no rust <200k miles power locks 4wd 4.0l 4 doors prefer: A/C power windows ABS (Fiancee drives during bad weather and has never driven a vehicle with out it) power mirrors hitch over head console...
  16. Jeepm@n

    Need some advice

    Ok I finally saved up around $2500. I need a replacement XJ as my 96 has serious rust going on the floor boards, rockers, and roof corners. Not only that it needs a new t-case, gas tank sending unit(leaks around tubings and electrical connector), alternator, and track bar. I'm thinking of just...
  17. Jeepm@n

    l423 cummins in a XJ?

    I found a XJ that someone swapped a 4 cylinder Onan Cummins diesel L423. How good of an engine is that? Would it still have plenty of power to cruise highway speeds and pass a slower vehicle without requiring a country mile? I'm thinking of buying it.
  18. Jeepm@n

    Source for new frame side track bar bracket?

    As the title states. I must be Google illiterate as I cannot locate a source for a stock track bar mount. Mine is wallowed out as there is nothing left to replace and it still has a wobble in the front end and I noticed some movement near that joint so I figured I'd replace it. I do not want a...
  19. Jeepm@n

    Fuel sending unit leaking?

    Filled the tank and new I had a slight gas leak. I found immediately after filling the leak was right where the wires and tube went through the sending unit. It is not the o-ring for the sending unit to tank. Is there a fix for this? Stealership wants $742.16 for the whole assembly only. Can I...
  20. Jeepm@n

    ultrasonic cleaning injectors

    Can I just drop my fuel injectors into my ultrasonic cleaner? I bought neon fuel injector's for my Jeep from the bone yard and want them cleaned before I install them. I do not have a pigtail to activate them.
Back
Top