- Location
- NE Texas
Easy job just time consuming... But it can be done in half a day if your focused
Prop the rig up on large jack stands and let the front axle droop.
Drain the oil & Pull the starter
Drop the 20ish 11mm bolts and 4(?) 13mm bolts to drop the oil pan
Pull the last bearing cap and use a small punch to tap the seal out of the block (screw driver can break a chunk of the journal.. Use caution!)
Slide the new one in and make it fit flush
Replace the lower peice in the bearing cap
Replace the cap & torque to spec (80ft/lbs iirc)
Put it all back together and viola!
After 3 weeks, My oil-pan is finally re-installed :smsoap: