What did you break on your XJ today
- Thread starter AwesomeXJ
- Start date
hards91xj
NAXJA Member #790
- Location
- Tacoma Wa.
That does suck ,that beats my breaking a windshield while wheeling on sat. ,I could still drive allday sat.
BenDiesel
NAXJA Forum User
- Location
- lynnwood washington
Awesome. I had my dizzy pop out on me twice. Only cause the hold down bolt wasn't tightend correctly
ceb0217
NAXJA Forum User
- Location
- oregon,corvallis
chech and make sure the dizzy didnt partly sieze up.I have a motor that has a bad cam from a part siezed dizzy.
Nealio240z
NAXJA Forum User
- Location
- Redding, CA
broke my 1 ton track bar rod end, sheared it right off. I was 70 miles from home =0
AwesomeXJ
NAXJA Forum User
- Location
- Vancouver WA.
Went out to TSF in the snow. Broke this while breaking trail on the top section of FB5 1st one on the trail in snow up to the top of my unit bearings.
crazymoose1990
NAXJA Forum User
- Location
- Beavertown
Aaron maybe you should turn out your steering stops. Was that side not replaced at TSF a few months ago? My Reid racing knuckes steering stops are cast long, I loose quite a bit of turning radius, however my steering stops keep my front axle shafts from binding when the wheels are fully locked. So a someone challenged can drive my Jeep like me and floor it with the wheels fully locked with out being concernd about u-joint binding. Or another thing that helps is replacing your u-joint for RCV the are really expensive but I bet you wouldnt break them, well maybe you could, but it would be really hard for you to do so. Also bigger axles help but they are really expensive. Or you could just by my Jeep, all it needs is a cage and a Tera low kit. I am unsure of the last statement right now? That would be the most expensive option also.
Last edited:
AwesomeXJ
NAXJA Forum User
- Location
- Vancouver WA.
Broke my drivers side leaf at the eyelet. Mall crawling at the no roads required show while on the RTI ramp.
bhmike
NAXJA Forum User
- Location
- Chandler, AZ
Steering box went out today
BPB
NAXJA Forum User
- Location
- Battle Ground, Washington
Broke my drivers side leaf at the eyelet. Mall crawling at the no roads required show while on the RTI ramp.
I take it that you are going to eliminate blocks now?
AwesomeXJ
NAXJA Forum User
- Location
- Vancouver WA.
kenny811
NAXJA Forum User
- Location
- Damascus, OR
Wana buy some?
AwesomeXJ
NAXJA Forum User
- Location
- Vancouver WA.
No I'm good
NW99XJ
NAXJA Forum User
- Location
- Gresham, Or.
bhmike
NAXJA Forum User
- Location
- Chandler, AZ
Durango box , jcr spacers, rustys track bar and box brace and not sure what I want to do for new steering rods . There's a guy selling a over the nuckle kit on Craigslist for 250 . Any suggestions or tips . Already have the old box and all the linkage out . Just need money for new stuff. Looks like ill be selling my stainless 1911 for jeep funds .
ruger81
NAXJA Forum User
- Location
- Battle Ground WA
How much for the 1911?
bhmike
NAXJA Forum User
- Location
- Chandler, AZ
600$
Springfield, stainless, wood grips, not even a year old , maybe 100 rounds though it .
AwesomeXJ
NAXJA Forum User
- Location
- Vancouver WA.
Bringing this one back, looks like a few guys may need it
Demonoid369
NAXJA Forum User
- Location
- Salem, OR
Might have broke my tilt steering column, it won't go up or down..... Lol
