Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
Can you rotate the motor 90 degrees? I would like the terminals for the motor to be on the front or back not he top as installed. If it can be rotated what bolts do I take out?
If I remember correctly you can only rotate it 180 from where it is, and the above PDF is going along with what I remember pull the 2 bolts on the end of the motor flip it over and put em back in; However the nuts on the other end of the bolts are usually just square nuts in a recess so you may have to pull the drum and everything if you knock one of them loose.
I will check with my rebuilder tomorrow and verify that.
J
If I remember correctly you can only rotate it 180 from where it is, and the above PDF is going along with what I remember pull the 2 bolts on the end of the motor flip it over and put em back in; However the nuts on the other end of the bolts are usually just square nuts in a recess so you may have to pull the drum and everything if you knock one of them loose.
I will check with my rebuilder tomorrow and verify that.
J
Once you remove those two bolts, you'll see that they are a few inches long. Pull them out about an inch, then pull the motor out just enough to rotate it (maybe a cm). When you pull it out, look for a small alignment pin. There will be holes for it at 0, 90, 180, and 270*. Just rotate that pin to whichever of those spots you want it in. I put mine backwards 90* so that the terminals and wires would be against my grill and out of the way. Don't worry about breaking any seals (like I was) because it actually has a sort of big o-ring that seals it up. Once you're done, just tighten those two bolts back up and you're done.
agreed, i just wanted to make sure i was on the same page. i mounted my control box under the hood, but i was still wondering about the motor rotation. thanks for all the info.