That cooler indicated is 1.5" thick. I think it will be too thick to fit in front of the AC condensor if you have one. The unit that most XJ'ers use is .75' (3/4") thick.
Same one im running! Did rip out my AC though, but it was not just to make it fit. Bet there is room, and the grille is just plastic so you could always notch a bit out.
Same one im running! Did rip out my AC though, but it was not just to make it fit. Bet there is room, and the grille is just plastic so you could always notch a bit out.
Same one im running! Did rip out my AC though, but it was not just to make it fit. Bet there is room, and the grille is just plastic so you could always notch a bit out.
its all good i have A.D.D. too i saw that too and was like WTF thats a pretty cool idea, there's another guy on here that has his mounted to his rear quarter panel.
i used that exact one and it took a while to squeeze it in there. it is barely touching the condenser, but it came with little pads so i put one between the cooler and cendenser. and i had to trim a small piece of my header panel. it was a huge PITA to git situated but i wanted to get it in instead of getting a thinner one. the B&M 70268 is the same height and width but half as thick. and i put mine in front of my mechanical fan so air is always moving across it.
