Things I need ASAP! :)

[Vanimal]

can you use an aftermarket one? i think most have enough travel to go to stock length. if that's the case, i have one.

 

[JeepCherokeeGuy99]

Hmm which aftermarket one is it? And what amount of lift was it designed for? It might just work!

 

[Vanimal]

i dont know, it's on my parts zj, but it looks like my rubicon express one on my xj. i can measure bushing to heim for you to see if it's short enough.

 

[JeepCherokeeGuy99]

If your zj is close to stock height then yes it should work. And the the end At the frame side has a joint right? Not bushing?

 

[Vanimal]

looks like 31.75 is the minimum adjustment on it.

 

[Vanimal]

If your zj is close to stock height then yes it should work. And the the end At the frame side has a joint right? Not bushing?

zj is not stock height but it has brackets for the track bar to compesate some. the body side is a heim joint. you would have to drill out the heim joint end hole in the body bracket to 5/8" i believe, then run a bolt through it.

 

[JeepCherokeeGuy99]

K I'll measure today and get back to you!

 

[Vanimal]

fwiw, it's about the same length as the rubicon express track bar on my xj. the xj has a bracket on the axle to compensate for the 4" of lift, and it previously used the stock track bar. the rubicon express track bar was pretty much a direct swap for the stock one when adjusted to it's minimum adjustment. i did not measure the stock track bar because it was trashed.

 

[Johnnie Walker]

RE1600 works on XJ/ZJ/TJ so should work fine. I had my RE1600 on before I put my lift springs in.

 

[Vanimal]

i cant imagine it would be too hard to find someone to trade this one for a stocker anyways.

 

[JeepCherokeeGuy99]

I'll take whatever works bro. I just need a mount now lol

 

[GrimmJeeper]

sorry been busy :doh: the problem is the parts pile is across town at my mom's place not here at my place. I should be able to get that thing in the mail tomorrow.

 

[Vanimal]

well i think i got one of those too. only problem is i need to swap it out for the double shear one i was planning on putting in. not sure when i'll get around to that.

 

[Vanimal]

good, looks like you're covered

 

[JeepCherokeeGuy99]

sorry been busy :doh: the problem is the parts pile is across town at my mom's place not here at my place. I should be able to get that thing in the mail tomorrow.

Mike your referring to just the mount right? The trac bar you had is still fubared or are you talking bout another one?

 

[JeepCherokeeGuy99]

Also if anyone has a leaf spring plate from a d35 please let me know. I kinda have one arranged with blondejoncherokee but he can't ship it till tuesday at the earliest! Has anyone driven a keep without one spring plate bolted down? Or without a Trac bar? I need to drive this thing about 5 miles from where it is now lol.

 

[Vanimal]

driving without the track bar will prove dificult and dangerous.

 

[JeepCherokeeGuy99]

Ya your right, better not risk it.

 

[Vanimal]

i can get you that track bar. i just gotta pull it off my zj. i also have to see if the heim will fit the 5/8" bolt because it's set up as double shear right now (the double shear bracket is going on my jeep).

 

[JeepCherokeeGuy99]

Sounds good. Thank you