Black1990jeep
NAXJA Forum User
- Location
- california
My front bumper is a round tubular type, about 3 inch diameter tube construction. I heard that this type of bumper is not safe for use as a jack point for a high lift jack, as the round tube can slide off the jack easier than if it was a square tube.
What is the scoop on this, safe or not?
if not safe are there attachments than have been made for this application, or should I weld some flat plates under the round tubes to give me a flat lift point?
thanks!
ps just got the jack mounted last night, mounts infront of the winch across the front of the jeep.
What is the scoop on this, safe or not?
if not safe are there attachments than have been made for this application, or should I weld some flat plates under the round tubes to give me a flat lift point?
thanks!
ps just got the jack mounted last night, mounts infront of the winch across the front of the jeep.