RWKHausSupply
NAXJA Forum User
- Location
- yorba linda, Cali
I have a Rear bumper that I am removing from the rear of my 1990. It is 3/16 " rect tubing that is incorporated in to a full hitch. It not only attaches to the rear bumper attachment holes but also to the frame / unibody rail in all 6 locations as the hitch does. This think will Not ever be pulled off... Used multiple times to attach a winch cable to as a achor point, also strap pulling.
THe corners were purposly left slightly further out from the body for a few reasons (exo attachment platforms, corner protection, etc), but can notched down if needed, easily.
As seen in picture below it is mounted as high as poss while allowing enough access room to the OE bumper mount area. I would NOT be selling this except that I am going to cut the rear and sheetmetal off and semi tube buggy it so this is not going to be used.
245$ Shipping is not really an option unless your willing to pay for it and it doesnt sell locally.
THe corners were purposly left slightly further out from the body for a few reasons (exo attachment platforms, corner protection, etc), but can notched down if needed, easily.
As seen in picture below it is mounted as high as poss while allowing enough access room to the OE bumper mount area. I would NOT be selling this except that I am going to cut the rear and sheetmetal off and semi tube buggy it so this is not going to be used.
245$ Shipping is not really an option unless your willing to pay for it and it doesnt sell locally.
