BIGSLVRXJ
NAXJA Forum User
- Location
- Des Moines, Iowa
Well since my current record of owning a RHD XJ is less than a week, I'm going to try to keep this one a little longer. I bought this from Brennen (chettacheez) on 6/3.
2000 Jeep Cherokee RHD-Silverstone Metallic, 175k miles, 4.0, AW4, NP231, D30, C8.25
These are the pictures Brennen sent me. I believe this was when he got it.
He was planning on lifting and wheeling it so he cut the fenders.
Since I'm planning on DD'ing this I'm going to put flares back on it and leave it near stock height. It just so happened that Dan (Fore Wheeler) had some pristine silver fenders (I wanted) and it also just so happened that my 8.25 had a limited slip (he wanted) so a trade was in order. He only lives about an hour and a half from where I picked the Jeep up so I went over and we did some good work. He got my cut fenders and LSD 8.25 and I got uncut fenders and flares and a non LSD 8.25. Again I am never going to wheel this one so I could care less about a Limited Slip.
Here I am tearing my old rear axle out at Wheeler's place.
And here are some pictures of it home.
2000 Jeep Cherokee RHD-Silverstone Metallic, 175k miles, 4.0, AW4, NP231, D30, C8.25
These are the pictures Brennen sent me. I believe this was when he got it.
He was planning on lifting and wheeling it so he cut the fenders.
Since I'm planning on DD'ing this I'm going to put flares back on it and leave it near stock height. It just so happened that Dan (Fore Wheeler) had some pristine silver fenders (I wanted) and it also just so happened that my 8.25 had a limited slip (he wanted) so a trade was in order. He only lives about an hour and a half from where I picked the Jeep up so I went over and we did some good work. He got my cut fenders and LSD 8.25 and I got uncut fenders and flares and a non LSD 8.25. Again I am never going to wheel this one so I could care less about a Limited Slip.
Here I am tearing my old rear axle out at Wheeler's place.
And here are some pictures of it home.
Last edited: