shortxjdoug
NAXJA Forum User
- Location
- Chattanooga tn
this is why he didnt want to get any closer to center first pic is the rotor Inside edge
![]()
second picture: the back side of the HUB, it has a largers diameter than the outside, he is pretty close to touching the side.
![]()
kinda wonder if its even possible anymore, i mean am i crazy to think that you can break the inside diameter of the rotor and it shouldnt matter... because it will have 5 studs holding it on? and the hub well... he could have gotten up next to the hubs outside diamter because all you have to do is grind off the stud a bit (which he had to do anyways)
so his only fear really was that the rotor would get messed up when drilling it or something...
this is why this conversion isnt that common, buuuut for a trail only vehicle i might run them, id have to look at em in person