Need To Borrow A Tool

[Kittrell]

Anyone have a slide hammer or a bearing puller that they could get to me this evening? I need to get a bearing race out of the end of my axle tube. I cut it out last time, but would rather go the easy route this time. I need to be mobile tonight for work (9:30 pm). So I'll cut it out if I have too. But if anyone can make it over here with one of those, it'd save me alot of hassle. About to hit the sack. I'll check this when I wake up (3-4). Thanks

- DJ

 

[JohnJohn]

Anyone have a slide hammer or a bearing puller that they could get to me this evening? I need to get a bearing race out of the end of my axle tube. I cut it out last time, but would rather go the easy route this time. I need to be mobile tonight for work (9:30 pm). So I'll cut it out if I have too. But if anyone can make it over here with one of those, it'd save me alot of hassle. About to hit the sack. I'll check this when I wake up (3-4). Thanks

- DJ

I use a wire pants hanger, the kind with the cardboard in the middle, that the pant hand on. Pull out the cardboard, cross it in half to create presure on the outside ends, bend the end tips to fit behind the race. After that I give is good yank. It's always worked for me.

I have the hanger I use in the garage if you need to tomorrow.

 

[YELLAHEEP]

JohnJohn IS a tool..........

 

[Kittrell]

Just cut 'er out, thanks guys.