muduck18
NAXJA Forum User
- Location
- Geigertown, PA
Re: NAC Lots-O- Posts Thread-Part Deux
its easy.
grinder + cutting wheel
start the jeep put it in 2wd
put it in drive or reverse let it idle
and cut it while the shaft is spinning, its hard to go wrong on that one..
if i did it. its easy
muddygp is right. i gotta put the yoke on there to seal it up. so theres no point in driving around front wheel drive cus ill have to drill, tap and put on the yoke anyways, so i might as well throw my new d/s in there too!
im still nervous about cutting this thing...
its easy.
grinder + cutting wheel
start the jeep put it in 2wd
put it in drive or reverse let it idle
and cut it while the shaft is spinning, its hard to go wrong on that one..
if i did it. its easy
