I've cut, shortened and straightened my re1660 trackbar so I could utilize the custom trackbar location on my new axle. I ran into a problem when my RE trackbar wouldn't fit in the fabbed up bracketry that was there, so I've plasma'd it all out to start over.
My question is; I have some 1/4" plate laying around and I should be able to fab up something similar to the JKS diy bracket. I've seen some fabbed brackets, so I know guys are doing it, but I also see a lot of pre fabbed, machined brackets.
My major delema is that the JKS is at least a week away....
Fab or not to fab???
My question is; I have some 1/4" plate laying around and I should be able to fab up something similar to the JKS diy bracket. I've seen some fabbed brackets, so I know guys are doing it, but I also see a lot of pre fabbed, machined brackets.
My major delema is that the JKS is at least a week away....
Fab or not to fab???