selarep
NAXJA Forum User
- Location
- Central CA
wow... do they offer some kind of warranty on thier $hitty labor?
I got new gears!!!
- Thread starter JoesXJ
- Start date
Shomsky462
NAXJA Forum User
- Location
- Atascadero, CA
Green98xj said:
i got my front 30 and rear 44 done there(4.88's and a detroit in back). $150 per axle out of vehicle
since i didnt buy the gears from them they didnt warranty them even though they were yukon. havent had any problems since i got them which was about a year ago. ive been to the rubicon, frank raines, hollister a couple times, and some other stuff.
selarep
NAXJA Forum User
- Location
- Central CA
Shomsky462 said:
where did you get yours done at?
Shomsky462
NAXJA Forum User
- Location
- Atascadero, CA
Green98xj said:
- Location
- Newark, CA
Letterman said:Rear End Specialtise sucks!!!! NEVER GO THERE!
Unless you like:
They did me so wrong! But they are cheep! :conceited
Ow, that looks like something I would do :shocked:
JoesXJ
NAXJA Forum User
- Location
- California
ok, I finally got my rear axle in yesterday (PIA) and drove it to Huntington Lake today. Holy crap!!! What a difference, feels like I'm driving around with V8 HP and torqe!.....I was able to go up the 4 lane doing 65 in cruise control with no downshifting. Also, as a BIG FAT BONUS, my gas milleage is almost 50% better than with the old gears. The only thing I need to do now is get a new spedo gear, my MPH are WAY OFF.
- Joe
*EDIT* Above claims where made using GPS since speedo is sooo far off.
- Joe
*EDIT* Above claims where made using GPS since speedo is sooo far off.
Last edited:
Matt S.
NAXJA Forum User
- Location
- Fresno, CA
Told you that you would like the 4.56 and 31s! Summer is looking good now!
selarep
NAXJA Forum User
- Location
- Central CA
hmmm.... maybe i should do 4.56's....
Letterman said:Rear End Specialtise sucks!!!! NEVER GO THERE!
Unless you like:
They did me so wrong! But they are cheep! :conceited
When Rear End Specialtise installed the gears in my Dana 30 they did not put ANY shims in the pinion, NONE!!!! There was no preload at all, the pinion was loose, I guess they thought there was a crush sleve? :laugh2: They also drilled the hole for the ARB too close to the UCA mount so I had to shave the arm and bolt to make it fit. I will not even get into what went wrong with the rear, but I will NEVER GO TO Rear End Specialtise again!
Go somewere else, pay more, and save some money!
