notamos
NAXJA Forum User
- Location
- Fort Collins, CO
I put a new heater core in last fall & have had a few problems since. I'm hoping one of you may have an idea what is going on.
-HVAC controls on the defroster only, it works properly (dash vent only)
-HVAC controls on the defroster/floor setting, it works properly (dash vent and floor, 50% each)
-HVAC controls on panel only (just air or AC), it works properly (panel vents only)
-HVAC controls on floor only, it blows out the panel vents 50% and the floor vents 50%
It is possible I hooked up something wrong but I'm not sure where to look. The blend door is operating correctly and the control seems to be working properly as it moves the actuators when I move it to each position.
Its bugging me because when I put it on the floor, I want it to blow there only. I hate the 50% mix.
Any thoughts on this?
-HVAC controls on the defroster only, it works properly (dash vent only)
-HVAC controls on the defroster/floor setting, it works properly (dash vent and floor, 50% each)
-HVAC controls on panel only (just air or AC), it works properly (panel vents only)
-HVAC controls on floor only, it blows out the panel vents 50% and the floor vents 50%
It is possible I hooked up something wrong but I'm not sure where to look. The blend door is operating correctly and the control seems to be working properly as it moves the actuators when I move it to each position.
Its bugging me because when I put it on the floor, I want it to blow there only. I hate the 50% mix.
Any thoughts on this?