- Location
- New Mexico
I installed a detroit and 4.56s in my 8.25 29 spline rear. Everything was going great until time to put the axles shafts in.
They go in fine, put the C-clip on but the C-clip will not go in the machined seat inside the carrier. I tried a smaller one and it will not go in either. Could the Detroit be machined wrong? Any ideas would be appreciated.
Thanks!
They go in fine, put the C-clip on but the C-clip will not go in the machined seat inside the carrier. I tried a smaller one and it will not go in either. Could the Detroit be machined wrong? Any ideas would be appreciated.
Thanks!