So riddle me this....
Why would I only have very low fan speed and very high fan speed. I have a 94 that has the little "rocker switch". The bottom two settings are the same(lo), the 3rd is the high speed, and the top settings is once again, the lo speed.
The blower motor went out and blew the 30a fuse, so I replaced it with one from NAPA and a new fuse. The switch(on the dash)looked burned and crusty so I replaced that. The brown plug that plugs into it was melted....so I went to a junkyard and spliced a new one in. And finally after reading all the "fan speed" searches on the 'net, I went and replaced the resistor..........and nothing changed.
I'm not picky, so having only lo/high is OK with me, but i'm just curious as to WHY the resistor did not fix my problem?
Any clue's?