xjh3
NAXJA Forum User
- Location
- Moodus, CT
Considering selling this setup.
D&D Machine billet aluminum 231 planetary doubler box - 2.72:1
Early Bronco D20 with Jeep t-case pattern conversion - 2.46:1 (I think)
D20 comes with twinsticks and broken Jeep speedo conversion thingy.
Together this gives 6:36:1 when both cases are in low.
I bought this setup but with a Box4rocks doubler from Bobnoxious a couple years ago. I replaced the doubler with the full billet machined housing. I have had no issues with this at all. It has taken a beating on 37s. Looking down the road, I need something stronger than a stock D20 and there really aren't any upgrades available. Rear 32 spline output can be had but no options for the front.
Would be an awesome setup for someone with a 5spd. If I remember correctly, a stock front driveshaft fit in the rear with my 8.8 pushed back 1". Front shaft will need to be lengthened.
I made a mount that bolts to the floor for the twinsticks. I modified the stock 231 shifter for use with the doubler. This will obviously require cutting the floor.
$1500/bo
Lemme know if you have any questions.
D&D Machine billet aluminum 231 planetary doubler box - 2.72:1
Early Bronco D20 with Jeep t-case pattern conversion - 2.46:1 (I think)
D20 comes with twinsticks and broken Jeep speedo conversion thingy.
Together this gives 6:36:1 when both cases are in low.
I bought this setup but with a Box4rocks doubler from Bobnoxious a couple years ago. I replaced the doubler with the full billet machined housing. I have had no issues with this at all. It has taken a beating on 37s. Looking down the road, I need something stronger than a stock D20 and there really aren't any upgrades available. Rear 32 spline output can be had but no options for the front.
Would be an awesome setup for someone with a 5spd. If I remember correctly, a stock front driveshaft fit in the rear with my 8.8 pushed back 1". Front shaft will need to be lengthened.
I made a mount that bolts to the floor for the twinsticks. I modified the stock 231 shifter for use with the doubler. This will obviously require cutting the floor.
$1500/bo
Lemme know if you have any questions.
Last edited: