Ok, so i know that this is not NAGCA but I'll ask anyway as I have two XJ's right now plus a ZJ. I recently swapped a later model high-pinion XJ front axle into my 96 ZJ, this was for a couple reasons, better clearance, better angles, the ZJ axle had bearings going out... but what this leaves me with is no way to adjust the caster or pinion angles as the 'frame' brackets aren't notched & it doesn't have the adjustment brackets in there, and the axle isn't notched nor does it have the horseshoe shaped cam brackets on the axle to lower control arm brackets.
So with all that said I got pretty lucky and the pinion is pretty straight with the front shaft, like .05*(or maybe it was .5*, either way...) based on the electronic angle finder, but I'd like to point it down just a little and get my caster just a little better. I know that I've seem one of the aftermarket vendors selling replacement/uprated/thicker horseshoe/cam brackets for the axle end then I could just notch the control arm mount.
Here is the question, does anyone know WHO sells that horseshoe bracket, or more accurately a set(4) of them?
Thanks
So with all that said I got pretty lucky and the pinion is pretty straight with the front shaft, like .05*(or maybe it was .5*, either way...) based on the electronic angle finder, but I'd like to point it down just a little and get my caster just a little better. I know that I've seem one of the aftermarket vendors selling replacement/uprated/thicker horseshoe/cam brackets for the axle end then I could just notch the control arm mount.
Here is the question, does anyone know WHO sells that horseshoe bracket, or more accurately a set(4) of them?
Thanks