Can't decide on which frame stiffeners

[knucklehead 61]

i have hd on my green heep & ruffstuff on my red heep.
the hd fit a shit-ton better than the ruffstuffs did.
i had to cut & modify the ruffstuffs while the hd's just fell into place perfectly.
if hd would make them in 3/16" rather than 10 gage they would be perfect in my opinion.

 

[MoparManiac]

I did 3/16 angle iron.

10 ga would have been better.

 

[twodoorXJ]

I had no fitment issues with my hd offroad engineeerings, i like them, and they weld up very nicely, with about a million plug welds.

 

[EricsXJ]

BrianHO,

Do your rear stiffeners wrap around the bottom of the frame rail also or are they just on the side?

 

[BRIANHO13]

BrianHO,

Do your rear stiffeners wrap around the bottom of the frame rail also or are they just on the side?

They plate the side of the frame rails.

 

[dhodgee]

I have TNT on the sides.
Honestly if you can I'd make my own on the side and then buy the front ones pre-made.

 

[supertrooper90]

If cost is a concern.... I would go with which ever one is less expensive. you are over thinking it. either one of these stiffeners will be a ton better than what you currently have. I personally went with the ruff stuff stiffeners, they were on sale around xmas and a %10 discount got them to my door for like $130 or so. And that was a good start for my 3 link up front.