MisterFubar
NAXJA Forum User
- Location
- Home
I sold my Scout and now I've got a D60F without a home.
$2650 OBO. Located in Gardner, KS. On the edge of the KC Metro area just off of I-35.
Can't ship it right now unless you can arrange to have it picked up here.
It's 85ish Dually Dodge Dana 60 front with 4130 35 spline outers and drive flanges, new spicer U-joints, 35 spline non-taper inners, an ARB with 4.56's, all new brakes, bearings and seals. Poison Spider Customs High steer arms. 1.5" .240 wall tierod/draglink with "1 ton" chebby tie rod ends, BTF uubolts and plates, 1410 yoke, Ruffstuff 3/8" steel diff cover with drain and fill plugs and I'm sure there is something else I'm forgetting.
Everything was replaced except the hubs, housing, knuckles and C's.
It sat under my Scout for about 6 months after I built it, but sadly I never drove on it.
I'll take some new pictures and post them up later...
I've also got a set of 5 H1 beadlocks with 36" bias tires, and a wide 14 bolt with a govlock, new everything and 4.56's that I'll be selling soon.
$2650 OBO. Located in Gardner, KS. On the edge of the KC Metro area just off of I-35.
Can't ship it right now unless you can arrange to have it picked up here.
It's 85ish Dually Dodge Dana 60 front with 4130 35 spline outers and drive flanges, new spicer U-joints, 35 spline non-taper inners, an ARB with 4.56's, all new brakes, bearings and seals. Poison Spider Customs High steer arms. 1.5" .240 wall tierod/draglink with "1 ton" chebby tie rod ends, BTF uubolts and plates, 1410 yoke, Ruffstuff 3/8" steel diff cover with drain and fill plugs and I'm sure there is something else I'm forgetting.
Everything was replaced except the hubs, housing, knuckles and C's.
It sat under my Scout for about 6 months after I built it, but sadly I never drove on it.




I'll take some new pictures and post them up later...
I've also got a set of 5 H1 beadlocks with 36" bias tires, and a wide 14 bolt with a govlock, new everything and 4.56's that I'll be selling soon.