Borla

[Kernel]

borla doesn't fit with any type of shackle lift. well at least mine didn't. had to hack the last foot off. welded a 45% section to that and brought it back through the spring. the header works good except for burning up the cps sensor. you either need to make a shield or rap it with some exhaust tape. i've had the setup for about 6yrs now.

 

[ChiXJeff]

borla doesn't fit with any type of shackle lift. well at least mine didn't. had to hack the last foot off. welded a 45% section to that and brought it back through the spring. the header works good except for burning up the cps sensor. you either need to make a shield or rap it with some exhaust tape. i've had the setup for about 6yrs now.

Any tailpipe with a stock-type Z-bend is going to interfere with a shackle lift, that's not just the Borla pipe.

Burning up the CPS? That's a new one.

I've had my Borla header and cat-back on for about 4 years now. Obviously, I don't expect them to cover rock rash, but my has been holding up okay. And their customer service has been pretty darned good in my book.

ChiXJeff

 

[Kernel]

whichever sensor is on the trany. header was melting the wire and loom after about 6 months. finally rapped the sensor with header tape and haven't had a problem for awhile. when the motor goes i'll go back and rap the header.

don't know if he has a lift.

 

[ChiXJeff]

whichever sensor is on the trany. header was melting the wire and loom after about 6 months. finally rapped the sensor with header tape and haven't had a problem for awhile. when the motor goes i'll go back and rap the header.

don't know if he has a lift.

That'd be the NSS probably on an auto, or the reverse switch on a stick. Either way, the wires have probably been misrouted at some point.

 

[XJHOX]

I bought one on close out special, and I still got screwed! It's not that great sounding, and like someone else said it will not work with lift shakels. I would not recomend it. my $.02