Safari Ary
NAXJA Forum User
- Location
- Virginia Beach, VA
Ok, I've got a tera 50 sitting here that was built to be 61" WMS to WMS using Ford 1/2 outers(would this change with chevy stuff?). I've also got a line on a Dana 60-2 out from under a FSJ PU I believe. It's 65" WMS to WMS with an offset diff. I'm planning on narrowing it up to run two short side shafts which will put it right at 61". My main question is will the fact that the width is the same front to rear drive me crazy?? I figure prolly not since the factory axles are only a quarter inch wider on each side in the front, so it's not gonna make that much diff. What do you guys think??
Also, anyone know how I would go about putting discs on the 60?? It is a SF 35 spline NON c-clip axle(as far as I know it's the only 35spline SF non c-clip out there). I did a quick search on Pirate, but nothing in particular came up, although I did see that Sean(oneton) had made his own brackets.
For those of you that are wondering what size tires I will be stepping up to that necessitates all this beef, never fear, I will still be running 33s Reason for all this is because I got the Tera 50 for practically nothin considering what it is, I'm tired of worrying about my 30, and the 8.25's gears howls so bad that I can't hear my radio sometimes.
One more thing, any tips or write-ups on narrowing an axle that I would find helpful?? Thanks
Ary
Also, anyone know how I would go about putting discs on the 60?? It is a SF 35 spline NON c-clip axle(as far as I know it's the only 35spline SF non c-clip out there). I did a quick search on Pirate, but nothing in particular came up, although I did see that Sean(oneton) had made his own brackets.
For those of you that are wondering what size tires I will be stepping up to that necessitates all this beef, never fear, I will still be running 33s Reason for all this is because I got the Tera 50 for practically nothin considering what it is, I'm tired of worrying about my 30, and the 8.25's gears howls so bad that I can't hear my radio sometimes.
One more thing, any tips or write-ups on narrowing an axle that I would find helpful?? Thanks
Ary