XJ tow hitch 2" receiver 5k lbs rated + eFans

01erionracing

NAXJA Forum User
Removed from 93 XJ great condition $25 no mounting hardware.
Contact Jimmy 951-21 nine sis six 3 one
20120814_230945.jpg


20120814_230923.jpg


Removed from 89 XJ great condition $35.00 mounting hardware included
20120814_231035.jpg


20120814_231130.jpg


4x 10" eFan $60.00 (3 used about 6 months and 1 brandnew)
20120814_230319.jpg
 
Is that $60 for ALL 4 fans? Or $60 EACH?

Also can you give me a measurement from mounting surface to top of motor, like if you lay it flat on a table and measured the height.

Thanks.
 
jumpnijeep
Yes $60 for all 4
I will measure the fan per your request and give you an update.

cal
With all 3 fans are on I dont hear it from the inside, when you are next to it of course you will hear the noise but not really loud.
 
I have a fan approx 2 feet behind my head, where the passenger rear window would be.

The fan that I'm using now is so loud I can't hear someone talking to me from outside the car.
 
I have a fan approx 2 feet behind my head, where the passenger rear window would be.

The fan that I'm using now is so loud I can't hear someone talking to me from outside the car.

I have installed quite a few different electric fans in the cars I have built/worked on, and IMHO your gonna be hard pressed to find a fan that moves enough air to be effective and is also quiet. I have a small 10 inch fan like these in my Mazda right now, and it moves a surprising amount of air but is fairly noisy when your next to it.


And yes please update with the measurement, I think can use these but need to check spacing first. Thanks.
 
Nealio240z
pm replied.

jumpnjeep
As promised please see picture below for the measurement. The measurement from center to center. There are 10 mounting points on the fan so there are several different mounting configuration.

20121009_184245_Mesured.jpg
 
Thanks for being so detailed, but I think I asked wrong I wanted to know how thick (I guess is the right word) the fans are.

If you lay it flat on a table and measure up off the table to the top of the motor housing.
Thanks, also it looks like they are sold now, so its kinda a pointless question now.

:)
 
Back
Top