Outlander560
NAXJA Forum User
- Location
- New York
Hey guys I have an xj 44 recently took it apart to weld a truss on and before I welded the truss on I checked the condition of the bearings when I pulled the shafts out of the axle. When looking at the axle shaft bearing cups pressed into the axle tubes they both were loose. Any one have any good tricks to get these from spinning?
Read a few ideas listed below not sure how well they will work but I'm curious what you guys think.
-Center punch to dimple the outer bearing cup and ID of the axle tube
-Green loctite
-Weld the bearing cup.
I remember a thread from a while back with someone having the same exact problem but I can't find it.
Any help is much appreciated guys.
Thanks.
Read a few ideas listed below not sure how well they will work but I'm curious what you guys think.
-Center punch to dimple the outer bearing cup and ID of the axle tube
-Green loctite
-Weld the bearing cup.
I remember a thread from a while back with someone having the same exact problem but I can't find it.
Any help is much appreciated guys.
Thanks.