2stix
NAXJA Forum User
- Location
- fallbrook Ca.
Looking for a clam shell type bearing puller for carrier/pinion bearings. used ok, but if anyone knows where in so cal i buy one new for a good deal, that would work too.
WTB Yukon bearing puller
- Thread starter 2stix
- Start date
GrimmJeeper
NAXJA Forum User
- Location
- Gardena, CA
Yukon as in Yukon gear & axle brand? if so obvious choice is Rob @ Rwkhaus in yorba linda.
2stix
NAXJA Forum User
- Location
- fallbrook Ca.
i didnt see any on his website. i guess i should have asked him while i had him on the phone today.
ok, did an better extensive search on his site and found it. even says in stock. i will give him a call in the morning.
ok, did an better extensive search on his site and found it. even says in stock. i will give him a call in the morning.
Last edited:
Vanimal
NAXJA Forum User
- Location
- escondido, ca
harbor freight one isnt too bad. i got one and put it through it's paces.
jeeperjohn
NAXJA Forum User
- Location
- Temecula, CA
Victor, I have one at the house you are welcome to borrow anytime.
WAZZUXJ
SoCal_XJ FB
- Location
- Aurora, CO
I just purchased one from Tom's Bronco Parts for $254 shipped last month.
2stix
NAXJA Forum User
- Location
- fallbrook Ca.
thats a great offer thanks John. but i just worked a deal with Robert to get one for me. he said it can be here by tomorrow, so i am in luck. i just needed one fast because i am releaved of baby duty for the next week and wanted to get as much done on the jeep as possible, and the gear/locker swap will be a lot easier out of the jeep.
thanks again for the offer. and if you want to come by and show me all the screw ups i did, your more than welcome any time.
thanks again for the offer. and if you want to come by and show me all the screw ups i did, your more than welcome any time.
