Would anyone be interested in.......

Beasley Knob is in the Brasstown Forestry Service's district in Blairsville,GA. Cost is $5 per vehicle per day. It's a good little trail with a couple of gnarly sections and one place that you'll get some pretty good trail rash on if you're not careful. For the most part it's mild to moderate.
 
I'm ready to go! But I look on yahoo maps and thier saying it will take 4 hours 30 mins. For me that's almost to tellico for me. Help me out am I right ?
 
:bawl: Yes again this sucks well I was hoping for a day trip. To many long trips :rattle: I'm going back to tellico labor day weekend. It's tellico or beasley's :cry:
 
headed out about 3pm, meet G mike around 6:45am sat at curt's.
 
Sorry guys wont be able to make it, radiator blew out, cant gewt a new one in till moday:mad: :mad: :mad: . Make sure to take some pics, so I have something to drool over! Kerry
 
Go ahead and see if her wants first dibs, I wouldnt be able to meet up for ahwile, but if u dont get another buyer, I`ll sport it in bout 2 weeks!
 
Georgia Mike said:
....an easy run? I'd like to check it out.

not a easy run!!!

going down rattlesnake hill (233)
1 right side rear bumper end cap pulled off.
2 gashes in left rear door.
1 left side rear flare AWOL, don't know where on the trail it is.
1 right front bumper cap smashed in.
1 roof rack side rails bent in 2+".
1 right front window in about 1 million pieces.
other than that, very much fun.

thanks, Georgia Mike.
 
Just remember the NAXJA SE's motto : "It's only sheetmetal!" :D That trail wasn't opened the last time we were up there,so,if anyone in the area wants to do a good,moderately difficult trail run one weekend,we'll go UP it instead! I'm up for it!! I'm ready to go back and do it again!! I'm just glad to see Beasley's returning to it's older glory. Mark,glad to see you made it home OK and I had a good time! See you in Tellico where the REAL trails are :laugh:
 
but it wasn't only sheetmetal, the door makes funny sounds when i close it like maybe a lot of broken glass inside.
 
Sounds like yall had fun see yall at (fall fing) marcas
 
"It's just sheetmetal........and glass!"

I can dig that!

I still haven't replaced my LRQ glass from Telllico... soon as I do, the rock lobster will pop up and claw at it again. Maybe once it gets cold I'll reconsider... Still need to scrog the other side so I can have 660 A/C
 
new glass being put in this am. but i did like my Home Depot window.
 
Back
Top